Recent content by Nerdx86

Is there any information for the electrical system for the printer( Schematics, drawings, etc?) before I start taking things apart?

Julian, Are there any official suggestions to adjust the voltage level or should I look at a third party power supply like I assume Christian is talking about above..

Yeah, I go into actions and push the Z+ button 1.5 million times.. :) (well maybe not that many, but it feels like it) :)

I don't speak German, but I am getting the lightning bolt frequently.. Someone in another thread reported that that was an undervoltage alert.. Can the admins confirm that this is the case?

Are there any specific specifications for the nozzles for the direct drive extruder? I'm looking at getting both 0.25 and a 0.6 mm units. I may even go larger for some structural prints.

Am I missing something or would a simple z axis rotation (To eject anything on the belt) be a really nice simple function on the Pi? I find it difficult to remove parts from the belt at times, and sometimes it even seems to fray the surface a little.. Any others having similar issues or am I...

On the good: other than the camera not seeming to work, I ran through the calibration and startup and printed a couple low resolution parts (0.3mm) easily and without issue. Z axis and extruder were both off, but did a rough recal and things looked good. I figure that I'll wait to hear from...

They must've missed one! Mine both were fine.. The usb "B" was quite a bit shorter than I would have liked ( mostly because the right angle goes the wrong way) but I just figure that I'll get a different one later. the micro USB (power to the PI) was long enough (but not excessive)...

Neither could I, but I saw that there were hardware changes with the firmware update, so I thought that I'd use what I had until I could figure out if I needed the update.. Does anyone know how to tell which firmware that we have?

Western Michigan in the US

Had a few gotchas during assembly: (Documenting for hopeful corrections) (and FYI, I actually watched the entire video assembly process first, but hadn't gotten the parts out yet so still missed a few details) 1. The video and pdf instructions go in different orders. Some assembly steps were...

But those screws are embedded under the print head, so I assume that I have to disassemble the printhead assembly so do so?