Search results

  1. C

    How to print a benchy and accomdate the initial overhang

    I'm trying that now, but I tilted the benchy 45 degrees with supports. So far, clean print. I do need that custom support app though.
  2. C

    Not printing properly

    I'm still on my first roll of PETG from ifactory. Not sure it was a single fix. LOL!! Being new to this, I had a comedy of errors from Z motors loosening to not knowing about the idler screw. I've had too loose of belt to over tight. Even releveling because the temporary stand it's on...
  3. C

    Not printing properly

    I have the ifactory download, I think Beta. Anyways, got it doing some nice prints, still need some adjusting to accomplish smooth and pretty. Don't know how to do that yet. It did take a lot of patience and adjusting. I knew it would be a challenge, not knowing what I was doing. I'm at the...
  4. C

    Not printing properly

    My Start code G90 ; Set to Absolute Positioning M82 ; Set extruder to absolute mode G21 ; Metric values M107 ; Start with the fan off G92 X0 Y0 Z0 E0 ; Set all axis to 0 G28 Y F1000 ; Home Y axis G28 X F1000 ; Home X axis G0...
  5. C

    Not printing properly

    I'm using cura download from ifactory with G code change from calibration instructions.
  6. C

    Not printing properly

    I've followed all the steps for calibrating and such. Went to do first print and it keeps starting and printing from about 4 inches above the bed. It does make nice swirly lines. What am I missing?
Top Bottom