English (US)

Reply to thread

Message: <blockquote data-quote="rwiggins" data-source="post: 314" data-attributes="member: 124"><p>The filament itself is very flexible, after adjusting heat settings up and down, I added a 25mm purge followed by a 25mm retract to my end gcode. It won't let me repeat print with these settings, but will allow for me to finish my project for the night. I will probably be looking into a bi-metal heat break vs the titanium in the near future to see if this alleviates the issue before I start leaning towards higher cooling for the heat break area</p></blockquote><p></p>

Top Bottom