Reply to thread

Message

<blockquote data-quote="rwiggins" data-source="post: 338" data-attributes="member: 124">I haven't yet pulled the power supply apart, but I am assuming there is a potentiometer that can be adjusted for out voltage. For the cord, I bought an extension. I could of cut one and ran it into the pi for power, but laziness prevailed. Their github is updated as of Sept. <a href="https://github.com/iFactory3D/iFactory3D-Direct-Drive" target="_blank">https://github.com/iFactory3D/iFactory3D-Direct-Drive</a>It took me a bit of searching before to find it since they don't update their main page or guide aside from new products..&nbsp; I have had a ton of issue with the direct drive setup, and am currently in the process of fitting a triangelab dragon hotend to it, and relocating the direct drive to the frame as a bowden. If you want the manufacturer of the extruder it is here: <a href="https://www.tronxyonline.com/Tronxy-BMG-Direct-Extruder-Kit-for-3D-Printer-V6-Version-p1796791.html" target="_blank">https://www.tronxyonline.com/Tronxy-BMG-Direct-Extruder-Kit-for-3D-Printer-V6-Version-p1796791.html</a> they added an E3D volcano block to it. I also sent them a power point of missing parts and issues that I had when building mine, while they were quick to offer me a pre published list of what the new model was, I never got a reply when I sent the power point.</blockquote>

[QUOTE="rwiggins, post: 338, member: 124"] I haven't yet pulled the power supply apart, but I am assuming there is a potentiometer that can be adjusted for out voltage. For the cord, I bought an extension. I could of cut one and ran it into the pi for power, but laziness prevailed. Their github is updated as of Sept. [URL]https://github.com/iFactory3D/iFactory3D-Direct-Drive[/URL] It took me a bit of searching before to find it since they don't update their main page or guide aside from new products.. I have had a ton of issue with the direct drive setup, and am currently in the process of fitting a triangelab dragon hotend to it, and relocating the direct drive to the frame as a bowden. If you want the manufacturer of the extruder it is here: [URL]https://www.tronxyonline.com/Tronxy-BMG-Direct-Extruder-Kit-for-3D-Printer-V6-Version-p1796791.html[/URL] they added an E3D volcano block to it. I also sent them a power point of missing parts and issues that I had when building mine, while they were quick to offer me a pre published list of what the new model was, I never got a reply when I sent the power point. [/QUOTE]

Name

Verification

Language Chooser

Search

Search

Reply to thread