English (US)
Language Chooser
English (US)
Deutsch (DE)
Search
Search titles only
By:
Search titles only
By:
Home
Forum
F.A.Q.
Media
Resources
Log in
Register
English (US)
Language Chooser
English (US)
Deutsch (DE)
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
Reply to thread
Home
Forum
iFactory3D One
Assembly and Construction
Which connectors did you use ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Philippe Beuthe" data-source="post: 287" data-attributes="member: 115"><p>Hello to the iFactory team,</p><p></p><p>I am busy studying an assembly where control panel, monitor, coil and end-of-filament control are all on the same side.</p><p>This involves reviewing the length of the cables.</p><p>I see you use AWG 24 cable tablecloths for control cables, and AWG 14 for power supplies.</p><p></p><p>Could you find out the connector references for:</p><p></p><p>- the orange connector (indicated "XT60") motherboard / heatbed,</p><p>- the 1x2 ckt connector of the motherboard / heatbed temperature control (Molex? But what type?),</p><p>- white 1x6 ckt connectors of axle motor controls.</p><p></p><p>Thank you in advance because it would make me save a lot of time!</p></blockquote><p></p>
[QUOTE="Philippe Beuthe, post: 287, member: 115"] Hello to the iFactory team, I am busy studying an assembly where control panel, monitor, coil and end-of-filament control are all on the same side. This involves reviewing the length of the cables. I see you use AWG 24 cable tablecloths for control cables, and AWG 14 for power supplies. Could you find out the connector references for: - the orange connector (indicated "XT60") motherboard / heatbed, - the 1x2 ckt connector of the motherboard / heatbed temperature control (Molex? But what type?), - white 1x6 ckt connectors of axle motor controls. Thank you in advance because it would make me save a lot of time! [/QUOTE]
Name
Verification
Post reply
Home
Forum
iFactory3D One
Assembly and Construction
Which connectors did you use ?
Top
Bottom
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
